Why do Hamilton Medical ventilators monitor static compliance (Cstat) instead of dynamic compliance (Cdyn)?
Static compliance represents pulmonary compliance during periods without gas flow, such as during an inspiratory pause. In Hamilton Medical ventilators it is obtained by the least square fit method described by Iotti1. An inspiratory pause or an inspiratory hold maneuver is not needed.
Static compliance (Cstat)
Dynamic compliance (Cdyn)
Depending on the measurement technique, Cdyn is prone to underestimating the total compliance of the lung and thorax as it is influenced by the resistive part of lung mechanics.
Continuous, reliable measurement of static compliance of the lung and thorax is of the upmost importance in state-of-the-art mechanical ventilation. Dynamic compliance cannot be considered a satisfactory substitute, as it is dependent on the airway resistance and can be misleading in various clinical conditions.
However, Cdyn is used in Hamilton Medical's ASV® mode to estimate the maximum tidal volume allowed, which is calculated as:
Cdyn x Pmax (Pmax = set alarm limit (Phigh)-10-PEEP).
- Iotti, G., & Braschi, A. (1999). Measurements of respiratory mechanics during mechanical ventilation. Rhäzüns, Switzerland: Hamilton Medical Scientific Library.
The content of this Knowledge Base is intended for informational purposes only. Hamilton Medical AG provides no warranty with respect to the information contained in this Knowledge Base and reliance on any part of this information is solely at your own risk. For detailed instructions on operating your Hamilton Medical device, please refer to the official Hamilton Medical Operator’s Manual for the respective device.